| 5.1 Surround Monitor Workaround [message #87165] |
Thu, 16 May 2019 03:54  |
quintusii
Messages: 26
Registered: April 2019
|
Junior Member |
|
|
I'm trying to setup a 5.1 monitor setup.
If I setup a monitor output in 5.1 the strips are only sending stereo to that output.
When I setup a 5.1 strip, I only see a stereo meter and it doesn't work either.
That's not working yet as it says in the "know issues"
What's the workaround?
LIO 3d, MacOS 12.6.1, ProTools 2022.10 Ultimate, Eucon, Reaper
|
|
|
|
|
|
|
|
|
|
| Re: 5.1 Surround Monitor Workaround [message #87534 is a reply to message #87533] |
Wed, 11 March 2020 05:51  |
quintusii
Messages: 26
Registered: April 2019
|
Junior Member |
|
|
Setting up a 5.1 Monitor Source works as expected. I was confuse, because you don't get any input metering.
To get that I had to make 5.1 strip in the mixer. That the weird part. You have to make a 5.1 bus in "Configure Mixer..."
Then you make a new input strip, select the 5.1 bus as output. then you can assign your inputs to "multi"
Once that is done you can also route the channel to a stereo bus. but you have no control how the downmix is done.
This is a bit weird.
Hope that helps.
LIO 3d, MacOS 12.6.1, ProTools 2022.10 Ultimate, Eucon, Reaper
|
|
|
|
Home
Search
Help
Register
Login
]