Metric Halo Discussion Forum
The place to talk MH!

Home   Search      Help    Register    Login
Home » Hardware » MIOConsole » 3d Console Monitor Setup
3d Console Monitor Setup [message #87612] Fri, 22 May 2020 20:54 Go to next message
Volod is currently offline  Volod
Messages: 1
Registered: May 2020
Junior Member
Hi guys, new here, need some help setting up the monitor controller in 3d console for my 2882. I want to route a stereo source from the Host to outputs 1-2 (monitors) 3-4 (sub), apply h/p l/p filters on them and have the monitor controller control their level together.

I've tried setting up the mains in quad output but I can't seem to route anything to Ls Rs. So what I've done instead is just set up two Aux's with Host as the input and applied filters on them, set the outputs as 1-2, 3-4 respectively, set up a common link group for them. But ideally I would like to use the monitor controller to set the level.

Can anyone help? Thanks!
Re: 3d Console Monitor Setup [message #87615 is a reply to message #87612] Mon, 25 May 2020 08:22 Go to previous message
Jerome Jay is currently offline  Jerome Jay
Messages: 3
Registered: April 2020
Junior Member
Hi,

you have to edit the output graph of your monitor controller, you'll find this function in the monitor menu, "Edit Current Monitor Output Graph"; then use the plugins to split the source signal, filter it, and root it to your outputs. (you can also add limiter, if you want, to prevent nasty peaks). I don't remember the exact plugins you need to use, but i know for fact that there's already topics about that in this forum.

Best regards, Jerome.
Previous Topic: Aes locking problem
Next Topic: MIOConsole 3d routing
Goto Forum:
  

[ PDF ]

Current Time: Fri Jul 10 02:25:56 EDT 2020