Metric Halo Discussion Forum
The place to talk MH!
Home   Search      Help    Register    Login
Home » Hardware » MIOConsole » Monitor Controller Input Source selection via Hardware
Monitor Controller Input Source selection via Hardware [message #87917] Thu, 18 February 2021 21:43
TAMAN is currently offline  TAMAN
Messages: 3
Registered: February 2021
Location: Hamurg
Junior Member
Hi,

I'm not sure if this is an "How to" question or an suggestion but I was wondering if it is possible to select the Monitor Input Source via the the hardware encoders on the ULN8 3d.
Like switching to I/O Trim > Input, Control Mode: Monitor, push one of the eight encoders to select a Monitor Controller Input Source.
Or switching to I/O Trim > Output, Control Mode: Monitor, push one of the eight encoders to select a Monitor Controller Output Source.

I saw that it's possible with Key Commands. Which is already pretty cool.

Greetings

Report message to a moderator

Previous Topic: Channelstrip3 vs MIOstrip
Next Topic: Is the preamp dead?
Goto Forum:
  

[ PDF ]

Current Time: Thu Sep 21 09:09:05 EDT 2023