Metric Halo Discussion Forum: Interfaces » Tech note 11

Home

Members

Help

Home » Hardware » Interfaces » Tech note 11 - still relevant for Pro Tools 10?

Show: Today's Messages :: Show Polls :: Message Navigator

Tech note 11 - still relevant for Pro Tools 10? [message #85378]

Thu, 12 July 2012 01:18

tinnyb
Messages: 2
Registered: July 2012

Junior Member

We are looking to buy a single ULN8 for use with Pro Tools 10. I'm wondering if the "important note about Pro Tools 9" in the tech note #11 applied to Pro Tools 10? Or has there been a fix?

(Ref: http://mhsecure.com/technotes/TechNote_0011/TN_0011.php)

Report message to a moderator

Re: Tech note 11 - still relevant for Pro Tools 10? [message #85381 is a reply to message #85378]

Thu, 12 July 2012 13:04

Allen
Messages: 138
Registered: July 2011
Location: The Mothership

Senior Member
Administrator

Avid has not fixed this issue yet.

Metric Halo
www.mhlabs.com
727-725-9555

Report message to a moderator

Re: Tech note 11 - still relevant for Pro Tools 10? [message #85382 is a reply to message #85381]

Thu, 12 July 2012 17:40

tinnyb
Messages: 2
Registered: July 2012

Junior Member

Thanks very much for your response. We are hoping to use a minimal-latency setup with PT 10 and ULN-8. In your opinion would working in aggregate mode in PT compromise this?

Report message to a moderator

Re: Tech note 11 - still relevant for Pro Tools 10? [message #85384 is a reply to message #85382]

Mon, 16 July 2012 12:52

Allen
Messages: 138
Registered: July 2011
Location: The Mothership

Senior Member
Administrator

It did not have any effect in our testing.

Metric Halo
www.mhlabs.com
727-725-9555

Report message to a moderator

Previous Topic:	LIO-8 Volume Control
Next Topic:	Recording stereo signal from mixing desk's line out into ULN2

Goto Forum:

-=] Back to Top [=-

[

]

Current Time: Sat May 18 06:38:24 EDT 2013