Metric Halo Discussion Forum: MIOConsole » How do I configure Outputs to Monitors and Sub simultaneously?

Home

Help

Home » Hardware » MIOConsole » How do I configure Outputs to Monitors and Sub simultaneously?

Show: Today's Messages :: Show Polls :: Message Navigator

How do I configure Outputs to Monitors and Sub simultaneously? [message #85499]

Mon, 29 October 2012 14:08

mommaerts
Messages: 7
Registered: October 2012

Junior Member

Hi, I've had my 2882 since 2003 and just this past month upgraded to 2D expanded DSP instead of purchasing an Apollo box. Mainly due to Metric Halo's reputation for service and upgradability.

So let's say I'm a complete newbie as I don't even know how to properly configure console connect with Logic despite watching several videos. So with that in mind here's my question:

Prior to upgrading my box I would have outs 1&2 going to my Left and Right monitors and simultaneously run outs 3&4 to my sub.

I've been trying to configure Monitor Control to do the same where I can have my Monitor Source run to a multiple Monitor Paths at the same time OR even better, configure 1 monitor path to send 2 stereo signal outs (2 x Stereo same signal full range out 1/2 and 3/4)

Seems like a pretty simple configuration which I can't figure out.

Thanks everyone,

M

Report message to a moderator

Re: How do I configure Outputs to Monitors and Sub simultaneously? [message #85502 is a reply to message #85499]

Mon, 29 October 2012 17:22

Allen
Messages: 156
Registered: July 2011

Senior Member

Please take a look at this video:

http://metric-halo.com/media/dsp/Bass_management.mov.zip

and let me know if it helps.

Metric Halo
www.mhlabs.com
727-725-9555

Report message to a moderator

Re: How do I configure Outputs to Monitors and Sub simultaneously? [message #85524 is a reply to message #85502]

Tue, 30 October 2012 23:16

mommaerts
Messages: 7
Registered: October 2012

Junior Member

Amazing...shows very clearly what I wanted to do and so much much more.

Thank you greatly. I'm surprised I didn't come across this tutorial video when I thought I downloaded them all.

Thanks again, wow, just amazing.

M

Report message to a moderator

Re: How do I configure Outputs to Monitors and Sub simultaneously? [message #85527 is a reply to message #85524]

Wed, 31 October 2012 12:42

Allen
Messages: 156
Registered: July 2011

Senior Member

No need to be surprised, as it hasn't been posted yet!

It will go up today. Glad to hear that it helped.

Metric Halo
www.mhlabs.com
727-725-9555

Report message to a moderator

Re: How do I configure Outputs to Monitors and Sub simultaneously? [message #85528 is a reply to message #85527]

Wed, 31 October 2012 13:20

mommaerts
Messages: 7
Registered: October 2012

Junior Member

Yes Allen, helped hugely and very well done.

Key for me was raising the send level and not worrying about the meters not moving on the post fader master.

Thanks!

M

Report message to a moderator

Previous Topic:	Mio in 64 bit?
Next Topic:	ULN-8/ Lio-8 as Dolby Surround device?

Goto Forum:

-=] Back to Top [=-

[

]

Current Time: Wed Mar 29 09:01:33 EDT 2023