Metric Halo Discussion Forum
The place to talk MH!
Home   Search      Help    Register    Login
Home » Hardware » MIOConsole » Pan automation with Logic and Mio (pan automation advice)
Pan automation with Logic and Mio [message #85819] Mon, 12 August 2013 10:21 Go to next message
quicksandjezus is currently offline  quicksandjezus
Messages: 14
Registered: September 2012
Location: The Netherlands
Junior Member
Working in Logic (X), I tend to be straight lined in my set up.
Channel 1 in Logic goes to DAW 1 in the Mio mixer. And summing is done in the Mio console.

As soon as I change the output from a logic channel to a Mio channel, the pan pot disappears, logically.
So panning is done in the Mio console. So far nothing strange I think.

But now I have a project of doing a few channels of panning automation.
Of course I can go for using Logic internally and put the stereo out to the Mio console, but I hate to lose the ability of DSP power per channel.

So the question is, How do you guys handle this ?

[Updated on: Mon, 12 August 2013 10:22]

Report message to a moderator

Re: Pan automation with Logic and Mio [message #85915 is a reply to message #85819] Thu, 14 November 2013 07:16 Go to previous message
Torsten Lang
Messages: 39
Registered: October 2013
Member
I got quiet the same problem here. I found this tutorial for Logic 8:
http://www.youtube.com/watch?v=n7auLelSvek
But as soon as i write some automation Logic becomes very slow and almost can't playback the audio.

But what do you mean by Mio channel? Are you refering to the other daw channels? Or is that something new. I dont have any so called mio channels in the dropdown output menues of logic

Report message to a moderator

Previous Topic: Move Mixer Volume Faders at once
Next Topic: Harrison Mixbus and Mio Console
Goto Forum:
  

[ PDF ]

Current Time: Tue Jun 06 13:12:47 EDT 2023