Metric Halo Discussion Forum
The place to talk MH!

Home   Search      Help    Register    Login
Home » Hardware » MIOConsole » Reamping with a ULN-2d and Torpedo Reload (Dry/wet tracking)
Reamping with a ULN-2d and Torpedo Reload [message #86411] Tue, 19 July 2016 21:25 Go to next message
zootermac is currently offline  zootermac
Messages: 12
Registered: July 2016
Junior Member
Hi
I'm having quite a frustrating time trying to perfect the reamping using a ULN-2d and Torpedo Reload (re-amp box).
I have no problem in recording a dry track, and using it to then record a reamped ("wet") signal onto a second track.

But, I cannot seem to find a solution that would let me audition amp tones in real time by playing back the pre-recorded dry track BEFORE recording the reamped track. It seems like the dry track is always outputting in serial through the Reload and back into the ULN-2d, and eventually out to main Stereo Out. Therefore, the dry signal is always tracking, which is not what I want when I'm trying to adjust amp tones. I want just the wet signal but it seems like I can't separate the dry/wet in parallel to remove the dry. Muting the dry output in MIO Console doesn't help.

My path:

DI input1 ULN-2d --> DAW input1 --> DAW output3 --> DAW3 MIO Console --> Analog1 Dir. Out MIO Console --> Analog1 Out ULN-2d --> Re-amp box in --> Amp --> Re-amp box loadbox out --> Input2 ULN-2d --> DAW input2 --> DAW St. Out --> DAW1/2 MIO Console --> Monitor Out


With this setup above, the dry always makes its way through to the return path to the ULN-2d and final Monitor Out. I appreciate any assistance!! Thanks

Re: Reamping with a ULN-2d and Torpedo Reload [message #86412 is a reply to message #86411] Wed, 20 July 2016 01:37 Go to previous messageGo to next message
tomg is currently offline  tomg
Messages: 33
Registered: June 2012
Location: denver, co
Member
Hi,

Have you tried this:

Re-amp box loadbox out --> Input2 ULN-2d --> direct out to DAW (via FW01 to FW18 --> monitor out ?

That way you can listen via monitor out before recording. You just have to set the record ready/enabled track in your DAW to "input off" so that you don't monitor the record-enabled track.

I hope that helps... it's kind of late here after a very long day of very different work - my engineering chops are not warmed up Smile

Best of luck,

Tom



Re: Reamping with a ULN-2d and Torpedo Reload. SOLVED! [message #86413 is a reply to message #86412] Wed, 20 July 2016 08:07 Go to previous message
zootermac is currently offline  zootermac
Messages: 12
Registered: July 2016
Junior Member
SOLVED!

Just had to Solo the main stereo out (DAW1/2) on MIO Console.
That's it.
Previous Topic: Replicate mixer for new unit
Next Topic: L/R not playing at same level in Mono
Goto Forum:
  

[ PDF ]

Current Time: Thu Sep 21 22:15:02 EDT 2023