Metric Halo Discussion Forum
The place to talk MH!
Home   Search      Help    Register    Login
Home » Hardware » MIOConsole » help with 3d console (lost )
help with 3d console [message #86899] Sun, 30 December 2018 12:26
fever is currently offline  fever
Messages: 13
Registered: September 2012
Location: Zurich, Switzerland
Junior Member
hi. for years i have been happily using my LIO with 8 preamp channels as the center piece of my audio system. the signal from my 3 turntables is amplified flat and routed to a mac mini on which i run a software called pureVinyl (pV; <http://www.channld.com/purevinyl/>) that does the RIAA-eq. i also use PV's built-in crossover to filter the signal for my tri-amplified horn system.

i feed 8 analog channels in (source switching is done by pV), and after pV's crossover i feed 6 filtered channels (LP, BP, HP) and 2 full range channels (for my stax headphone amp) back to the LIO.

yesterday i installed the 3d card in the LIO, installed the new firmware and the new 3d console.

this is where the problems start... i am completely lost setting the new console up so it works like the 2d console did.

for instance i have no idea how to create the 8 output channels.

i have tried to replicate the monitor control settings from my old console for a 5.1 setup ... with minimal success. i now have the fullrange signal coming out of my left 15" woofer...

i have attached screenshots of my old settings and would be very thankful if somebody could walk me through step by step so that i can listen to my music again. thanks in advance!

index.php?t=getfile&id=161&private=0
index.php?t=getfile&id=162&private=0
index.php?t=getfile&id=163&private=0
index.php?t=getfile&id=164&private=0

Report message to a moderator

Previous Topic: DAW & mixing in MIO console
Next Topic: NEWBIE Question, I think I might have killed my 2882
Goto Forum:
  

[ PDF ]

Current Time: Sat Mar 25 07:30:36 EDT 2023