Metric Halo Discussion Forum
The place to talk MH!
Home   Search      Help    Register    Login
Home » Hardware » MIOConsole » Sending stereo output to single monitor
Sending stereo output to single monitor [message #86952] Thu, 07 February 2019 14:27 Go to next message
jaaneman is currently offline  jaaneman
Messages: 5
Registered: February 2019
Location: USA
Junior Member

First post Razz

I started mixing in mono with a single monitor and I get good results, but I can't seem to figure out how to get a stereo signal to the monitor. I only get mid and left signal.

In monitor control I set source to Daw 1 and Daw 2 and the path to a mono bus which defaults to Left, then I send that to output Monitor L.

This receives the middle and left side of the mix but nothing from the right.

Is there a way to send the stereo signal to a mono output via Monitor L so that I can also hear what is panned hard right?

I'm sure there is, but I can't get my head around it Confused

Thanks for your help

Report message to a moderator

Re: Sending stereo output to single monitor [message #86954 is a reply to message #86952] Thu, 07 February 2019 15:05 Go to previous message
bj is currently offline  bj
Messages: 614
Registered: July 2011
Senior Member
Administrator
Have you tried hitting the "Mono" button in the MC?

Report message to a moderator

Previous Topic: The v5.4d228 driver is glitchy on Mountain Lion!!
Next Topic: clocking, I/O, and monitoring [!!
Goto Forum:
  

[ PDF ]

Current Time: Wed Mar 29 13:09:17 EDT 2023