Metric Halo Discussion Forum
The place to talk MH!

Home   Search      Help    Register    Login
Home » Hardware » Interfaces » Using a 2882 as an ADAT 'expander'
Using a 2882 as an ADAT 'expander' [message #87054] Fri, 29 March 2019 06:34 Go to next message
StephenBennett is currently offline  StephenBennett
Messages: 14
Registered: July 2013
Junior Member
Hi all

I use the 2882 as an extra 8 channels with my ULN-2.

I'd like to take the 2882 to a colleague's studio and use it with their two channel interface which has optical in.

Does anyone do this? Use a 2882 just as an expander?

Will the 2882 just appear as extra in puts in the DAW? Or will we need to run the Console as well (no FW on the colleagues computer)

We'll just be using line inputs, so I assume we can save the 'state' of the 2882's inputs before the move?

Stephen

Re: Using a 2882 as an ADAT 'expander' [message #87056 is a reply to message #87054] Fri, 29 March 2019 14:02 Go to previous messageGo to next message
bj is currently offline  bj
Messages: 434
Registered: July 2011
Senior Member
Are you on 2d or on 3d? I'm guessing 2d since you mention FireWire.

With 2d you can set up the routing as desired and save a boot state.

If you need help with this, open a support ticket.
Re: Using a 2882 as an ADAT 'expander' [message #87068 is a reply to message #87054] Mon, 08 April 2019 07:48 Go to previous message
StephenBennett is currently offline  StephenBennett
Messages: 14
Registered: July 2013
Junior Member
Thanks both--good to know.

Yes, 2d.

Stephen
Previous Topic: MH Link vs USB driver : Latency
Next Topic: Lio 8 latency in logic 3d vs firewire
Goto Forum:
  

[ PDF ]

Current Time: Sat Oct 24 14:12:41 EDT 2020