Metric Halo Discussion Forum
The place to talk MH!

Home   Search      Help    Register    Login
Home » Hardware » MIOConsole » 3d questions (Need clarification on 3d bus abilities)
3d questions [message #87600] Tue, 19 May 2020 15:06 Go to next message
Lt030 is currently offline  Lt030
Messages: 5
Registered: May 2020
Location: Minneapolis
Junior Member
Spending a little more time with 3d. Cannot find a simple toggle button for switching bus sends between pre and post fader other than opening up mixer configuration each time.

Also seem to be unable to take a send from the main output to create a separate output bus for control (crossover and level) of my monitor sub as I do with 2d.

Do either of these possibilities exist in 3d at this time?

Thank you

David
Re: 3d questions [message #87601 is a reply to message #87600] Tue, 19 May 2020 16:06 Go to previous messageGo to next message
bj is currently offline  bj
Messages: 405
Registered: July 2011
Senior Member
Quote:
Spending a little more time with 3d. Cannot find a simple toggle button for switching bus sends between pre and post fader other than opening up mixer configuration each time.


That is not in there yet. Are you looking to do this per-strip, or per bus?

Quote:
Also seem to be unable to take a send from the main output to create a separate output bus for control (crossover and level) of my monitor sub as I do with 2d.


You can make an aux input that you feed with the Main bus and send that to another bus.

However, for what you describe, I think you would be better off using a graph in the Monitor Controller.
Re: 3d questions [message #87602 is a reply to message #87601] Tue, 19 May 2020 16:23 Go to previous messageGo to next message
Lt030 is currently offline  Lt030
Messages: 5
Registered: May 2020
Location: Minneapolis
Junior Member
I prefer per strip for pre / post send. Didn't realize one could use a graph in monitor controller. Will check into it. Thank you.
Re: 3d questions [message #87603 is a reply to message #87602] Tue, 19 May 2020 17:28 Go to previous messageGo to next message
Lt030 is currently offline  Lt030
Messages: 5
Registered: May 2020
Location: Minneapolis
Junior Member
Checking into 3d monitor graph I am not seeing a way to create multiple analog output paths to be used at same time.
Re: 3d questions [message #87604 is a reply to message #87603] Tue, 19 May 2020 17:58 Go to previous message
bj is currently offline  bj
Messages: 405
Registered: July 2011
Senior Member
Quote:
I prefer per strip for pre / post send.


Ok; thanks for the feedback.

Quote:
Checking into 3d monitor graph I am not seeing a way to create multiple analog output paths to be used at same time.


You need to make (or modify) an monitor output that is large enough to cover your output channels. So if you were doing 2.1, you could use LCR, and use the C as your sub output.

Then your stereo source comes in on L + R in the graph, and you add the processing and calibrartion in the graph to send your sub out the C path, and connect the sub channel to wherever you have C routed. You can do similar things if you have 2.2 or 5.1 etc.

If you need more help with this, please open a support ticket.
Previous Topic: Switching from OSX to Windows10 with ULN-2 3d
Next Topic: Aes locking problem
Goto Forum:
  

[ PDF ]

Current Time: Fri Jul 03 09:41:52 EDT 2020