Metric Halo Discussion Forum: MIOConsole

Home

Help

Home » Hardware » MIOConsole » Aes locking problem

Show: Today's Messages :: Show Polls :: Message Navigator

Aes locking problem [message #87606]

Fri, 22 May 2020 04:41

Obefreq
Messages: 15
Registered: January 2020
Location: Poland

Junior Member

Hello,

I have a problem with minidsp 88d and lio 3d
Minidsp have asynchronous aes and when connect it mh show me yellow aes wild or when I change to 48k its red.
On previous 2d all was working now after upgrade stopped. Is it any chance someone had same issue? Any solution?

Regards

Report message to a moderator

Re: Aes locking problem [message #87607 is a reply to message #87606]

Fri, 22 May 2020 05:22

bj
Messages: 614
Registered: July 2011

Senior Member
Administrator

Are you connecting in a loop? E.g. LIO-> minidsp -> LIO?

If so are you using channels 1+2 on the minidsp?

If you are doing that the minidsp should be putting out audio that is clocked at the same rate as the LIO.

If not, please explain how things are connected.

How is the LIO clocked?

Report message to a moderator

Re: Aes locking problem [message #87608 is a reply to message #87607]

Fri, 22 May 2020 05:41

Obefreq
Messages: 15
Registered: January 2020
Location: Poland

Junior Member

Hi,

I have 2+1 setup, so I connected in loop aes 1+2 and 3+4 to minidsp 1+2 and 3+4 and same Back to lio but in minidsp I use only 1,2,3 for correction. 1/2 for speakers and 3 for sub.

Report message to a moderator