| 3d Console Monitor Setup [message #87612] |
Fri, 22 May 2020 20:54  |
Volod
Messages: 1
Registered: May 2020
|
Junior Member |
|
|
Hi guys, new here, need some help setting up the monitor controller in 3d console for my 2882. I want to route a stereo source from the Host to outputs 1-2 (monitors) 3-4 (sub), apply h/p l/p filters on them and have the monitor controller control their level together.
I've tried setting up the mains in quad output but I can't seem to route anything to Ls Rs. So what I've done instead is just set up two Aux's with Host as the input and applied filters on them, set the outputs as 1-2, 3-4 respectively, set up a common link group for them. But ideally I would like to use the monitor controller to set the level.
Can anyone help? Thanks!
|
|
|
|
| Re: 3d Console Monitor Setup [message #87615 is a reply to message #87612] |
Mon, 25 May 2020 08:22  |
Jerome Jay
Messages: 3
Registered: April 2020
|
Junior Member |
|
|
Hi,
you have to edit the output graph of your monitor controller, you'll find this function in the monitor menu, "Edit Current Monitor Output Graph"; then use the plugins to split the source signal, filter it, and root it to your outputs. (you can also add limiter, if you want, to prevent nasty peaks). I don't remember the exact plugins you need to use, but i know for fact that there's already topics about that in this forum.
Best regards, Jerome.
|
|
|
|
Home
Search
Help
Register
Login
]