Metric Halo Discussion Forum
The place to talk MH!
Home   Search      Help    Register    Login
Home » Hardware » MIOConsole » Sending an Aux to an Aux?
Sending an Aux to an Aux? [message #87749] Wed, 23 September 2020 05:18 Go to next message
thedeadsea is currently offline  thedeadsea
Messages: 3
Registered: September 2020
Location: Australia
Junior Member
Hi - apologies in advance if this query is a case of missing the obvious...

I have MIOConsole3D set up such that I send to the headphones via an Aux with a direct insert to feed headphone outputs on that Aux. But I also want to be able to send the Haloverb I have set up on a different Aux to the headphone Aux... I'm sure I'm missing something, but it doesn't seem possible to send one Aux to another Aux?

Any advice appreciated!

Tim

Report message to a moderator

Re: Sending an Aux to an Aux? [message #87750 is a reply to message #87749] Wed, 23 September 2020 13:19 Go to previous messageGo to next message
bj is currently offline  bj
Messages: 621
Registered: July 2011
Senior Member
Administrator
You need to add a new input strip, set the Reverb Aux bus to be the source on that input strip, and then send that strip to your headphone aux. You should use the reverb 100% wet for this configuration.

Report message to a moderator

Re: Sending an Aux to an Aux? [message #87752 is a reply to message #87750] Wed, 23 September 2020 19:38 Go to previous messageGo to next message
thedeadsea is currently offline  thedeadsea
Messages: 3
Registered: September 2020
Location: Australia
Junior Member
Of course! That makes a lot of sense.

Much appreciated BJ

Report message to a moderator

Re: Sending an Aux to an Aux? [message #87753 is a reply to message #87749] Wed, 23 September 2020 19:42 Go to previous message
thedeadsea is currently offline  thedeadsea
Messages: 3
Registered: September 2020
Location: Australia
Junior Member
One more related question - is there a reason that Aux strips don't/can't have direct out slots? Of course it's fine to use an I/O insert plugin to achieve the same end, but just wondering if this is a possibility.

Report message to a moderator

Previous Topic: Avid Control connection with MIO/ DSP Plugin control (?)
Next Topic: Phasing on Main Output´s ULN-8 3d
Goto Forum:
  

[ PDF ]

Current Time: Sat Jun 03 16:40:24 EDT 2023