Metric Halo Discussion Forum
The place to talk MH!

Home   Search      Help    Register    Login
Today's Messages (off)  | Unanswered Messages (on)

Forum: MIOConsole
 Topic: Monitor Controller Input Source selection via Hardware
Monitor Controller Input Source selection via Hardware [message #87917] Thu, 18 February 2021 21:43
TAMAN is currently offline  TAMAN
Messages: 1
Registered: February 2021
Location: Hamurg
Junior Member
Hi,

I'm not sure if this is an "How to" question or an suggestion but I was wondering if it is possible to select the Monitor Input Source via the the hardware encoders on the ULN8 3d.
Like switching to I/O Trim > Input, Control Mode: Monitor, push one of the eight encoders to select a Monitor Controller Input Source.
Or switching to I/O Trim > Output, Control Mode: Monitor, push one of the eight encoders to select a Monitor Controller Output Source.

I saw that it's possible with Key Commands. Which is already pretty cool.

Greetings
Forum: Interfaces
 Topic: MH 2882 no firewire light on front panel
MH 2882 no firewire light on front panel [message #87919] Sun, 21 February 2021 09:42
AndersC is currently offline  AndersC
Messages: 1
Registered: February 2021
Location: Denmark
Junior Member
Hi.

My Metric halo 2882 wont connect to macbook, and MIO console does not register any device.

I use the MIO 5.6.12.224

Theres no light in the FW on front panel.

When i connect FW cable only samplerate, clock, ditigal I/O, power and LOCKED is lit up.

I had the problem before where I ran a erase bootstate. but cant seem to find the file on my macbook.


Any help would be appreciated.

Thanks Smile



Current Time: Wed Feb 24 15:56:14 EST 2021