Metric Halo Discussion Forum: MIOConsole

Sat, 08 November 2014 17:53

jhcore
Messages: 4
Registered: November 2014

Junior Member

I just picked up a used 2882+DSP box today. It's playing nice with my OS (10.7), the MBP is bus-powering it, and Logic is routing everything through it properly. However, for the life of me, I can't seem to get the Monitor Controller to kick in. No matter what I do, the dial in the UI is greyed out. The tutorial video clearly shows a "Monitor R/L" option in the config dropdown, but I don't have that option (nor do I know if that's why my option is greyed out!). The levels from this MIO box are LOUD, and I'm looking for a way to temper the dbs without getting some kind of pad before the monitors.

Also, I didn't realize that one of my analog outs would be taken up by monitors. Normally I run 8 outs into a Folcrom, then back into the DAW. Now I only have six outs to play with! Would a workaround be to link up my old Saffire 40 and monitor through that?

Report message to a moderator