Metric Halo Discussion Forum
The place to talk MH!

Home   Search      Help    Register    Login
Home » Hardware » Interfaces » S/PDIF 3d card - internal vs external clocking
S/PDIF 3d card - internal vs external clocking [message #87570] Mon, 20 April 2020 06:13 Go to previous message
stickman is currently offline  stickman
Messages: 8
Registered: August 2019
Location: Berlin
Junior Member
Hi, i have a Kemper and my snake is not long enough to connect it via line-in to my LIO so i tried it's SPDIF out. The Kemper however can only work when it's the master clock. When i try to run it at 96 sample rate i get crackling. I can normally run the LIO-8 at even higher sample rates without crackling. Since i'm only monitoring in the MIO panel i guess there is no buffer setting i can adjust for the S/PDIF in ?

What would be the the pros of using the LIO as a master clock (despite the Kemper not being able to do this) and/or disadvantages of clocking the LIO to the Kemper ?

Also another related question: can i use the front panel DI inputs as a 'normal' line input (similar to thedb25 inputs on the back), is there a setting in the MIO where i can switch these inputs or are they always in DI-mode?

[Updated on: Mon, 20 April 2020 06:15]

Report message to a moderator

Read Message
Read Message
Read Message
Read Message
Previous Topic: Unable to Verify Eligibility
Next Topic: ULN8 in Standalone for Windows
Goto Forum:

[ PDF ]

Current Time: Sat Sep 26 05:38:39 EDT 2020