Metric Halo Discussion Forum: MIOConsole » Pan automation with Logic and Mio

Pan automation with Logic and Mio [message #85819]

Mon, 12 August 2013 10:21

quicksandjezus
Messages: 14
Registered: September 2012
Location: The Netherlands

Junior Member

Working in Logic (X), I tend to be straight lined in my set up.
Channel 1 in Logic goes to DAW 1 in the Mio mixer. And summing is done in the Mio console.

As soon as I change the output from a logic channel to a Mio channel, the pan pot disappears, logically.
So panning is done in the Mio console. So far nothing strange I think.

But now I have a project of doing a few channels of panning automation.
Of course I can go for using Logic internally and put the stereo out to the Mio console, but I hate to lose the ability of DSP power per channel.

So the question is, How do you guys handle this ?

[Updated on: Mon, 12 August 2013 10:22]

Report message to a moderator