Metric Halo Discussion Forum: MIOConsole

Thu, 21 January 2016 23:33

elsie
Messages: 3
Registered: January 2016
Location: new york

Junior Member

i recently upgraded to el capitan. i upgraded the firmware, downloaded the mio console and when i fired it up, i was presented with a huge mixer that i havent seen before and the normal routing output patchbay was no longer there. the mixer doesnt seem to function with the 2882, i can get signal in ( i can see it on the meters on the 2882hardware) , i can play back on channels 1 and 2 but i cannot alter the output patchbay because its no longer there on the console. what have i done wrong? where has the output patchbay gone?

Report message to a moderator