Metric Halo Discussion Forum: MIOConsole » Routing to multiple headphones

Routing to multiple headphones [message #86392]

Thu, 09 June 2016 21:57

dasnub
Messages: 3
Registered: June 2016

Junior Member

Hi all,

Mindblown new guy here trying to figure out how to do the following... hoping you can help me out. This can't be that hard and yet I'm struggling.

- Using Logic 9. I have never had to use analog outs before and so have nothing set up in the Logic mixer except output 1-2.
- Using Basic ULN8 Template
- Want to send two extra sets of can mixes to my live room from mix room. I have custom panels in the wall of each room that are connected so I can have the mix room sealed off from the live room during recording. The live room headphones are attached to line outs 1-2 and 3-4 on the back of the unit and directly into the wall panel.
- I want separate volume control in the mixer for my monitors and both sets of headphones.
- Right now I can't figure out if there's a way to separate the monitor volume from the analog 1-2 volume somehow. I had Redco make a line out snake with 2 headphone outs and 4 XLRs. The headphone outs are on 1-2 and 3-4. Think maybe I've just made a cable design error, but wonder if I can somehow manipulate the routing in the Daw and MIO to make it work.

Thanks in advance for any help!

Report message to a moderator