Metric Halo Discussion Forum: MIOConsole » Sending stereo output to single monitor

Sending stereo output to single monitor [message #86952]

Thu, 07 February 2019 14:27

jaaneman
Messages: 5
Registered: February 2019
Location: USA

Junior Member

First post Razz

I started mixing in mono with a single monitor and I get good results, but I can't seem to figure out how to get a stereo signal to the monitor. I only get mid and left signal.

In monitor control I set source to Daw 1 and Daw 2 and the path to a mono bus which defaults to Left, then I send that to output Monitor L.

This receives the middle and left side of the mix but nothing from the right.

Is there a way to send the stereo signal to a mono output via Monitor L so that I can also hear what is panned hard right?

I'm sure there is, but I can't get my head around it Confused

Thanks for your help

Report message to a moderator