Metric Halo Discussion Forum: MIOConsole » 3D assigns to host in odd numbers

3D assigns to host in odd numbers [message #87953]

Fri, 02 April 2021 14:06

scardanelli
Messages: 21
Registered: January 2014
Location: Merléac, Brittany, Franc...

Junior Member

So, new setup with the just installed 3D card in my ULN-2

The default set up gave me the 2 analogue inputs, routed as Pre 1 & Pre 2 to host. Then I added 16 channels for my ADAT inputs, and these started at the number 4 - meaning all my inputs are offset in my DAW.

I can see no way of altering this - when add inputs strip is used it automatically assigns a "to host" number - how do I change this? And where has host channel 3 gone?

Am I going to have to manually add an extra channel at the end and shuffle every single inputs over by one, and rename everything....?

Also meant to add -when I do a save of the console, the screen turns completely black, I have to tab away from the app and then back again to get the console view back.

Thanks

[Updated on: Fri, 02 April 2021 14:13]

Report message to a moderator