Metric Halo Discussion Forum: Interfaces

Home

Help

Home » Hardware » Interfaces » Stuck at 96k! (Stuck at 96k after hard reset)

Show: Today's Messages :: Show Polls :: Message Navigator

Stuck at 96k! [message #86400]

Thu, 23 June 2016 08:15

philturcio
Messages: 1
Registered: June 2016
Location: Australia

Junior Member

Hello,

I decided to hard reset my Metric Halo to see if I could get my ADAT outputs to work correctly. I then uploaded the current firmware, but it is now locked to 96k, and seems to have no serial number -

It's been years since I had to do anything to this unit (it's pre 2d card), as it has been rock solid - I'm not sure how to get it back up and running -

Any help would be greatly appreciated!

Phil

Report message to a moderator

Previous Topic:	API 2500 will not work with ULN-8 direct outs !
Next Topic:	When Will Metric Halo be Windows Ready?

Goto Forum:

-=] Back to Top [=-

[

]

Current Time: Sat Jun 03 07:55:42 EDT 2023