Metric Halo Discussion Forum
The place to talk MH!

Home   Search      Help    Register    Login
Home » Hardware » Interfaces » RODE NT1-A direct to ULN-2 (mic pre gain)
RODE NT1-A direct to ULN-2 [message #86903] Wed, 02 January 2019 17:23
rJames is currently offline  rJames
Messages: 1
Registered: January 2019
Junior Member
Hi, I have had a ULN2 for 12+ years. Still working. I was using a mixer so my setup was consistent for guitar and mics. My mixer is adding lots of noise so I'm now hoping to go direct.

My guitars seem to be fine.

I don't seem to have any control over mic input volume. I'm sure it is operator error so I need help.
I have phantom power on.
trim off
gain know labeled 6-72 seems to have no effect.
Can't see how to change gain from the MIO console.

I do have a decent level from mic if I am right up on it. But I need to record a violin soon and will need better control of gain.

I'd love to know what I'm doing wrong. Help. Thanks, Ron
Previous Topic: Thunderbolt usage and Firewire
Next Topic: Breakout box for ADAT ports on 2882
Goto Forum:

[ PDF ]

Current Time: Tue Jun 06 12:51:31 EDT 2023