Metric Halo Discussion Forum: Interfaces » 2 computers 1 interface

Home

Help

Home » Hardware » Interfaces » 2 computers 1 interface (hardware)

Show: Today's Messages :: Show Polls :: Message Navigator

2 computers 1 interface [message #87341]

Sat, 21 September 2019 16:01

dragosgd
Messages: 2
Registered: September 2019
Location: Dallas TX

Junior Member

Can I connect 2 computers to my 2882 3D via MHLink? Thanks.

Report message to a moderator

Re: 2 computers 1 interface [message #87342 is a reply to message #87341]

Sat, 21 September 2019 16:55

bj
Messages: 638
Registered: July 2011

Senior Member
Administrator

Not simultaneously, at the present time.

You can, however, connect one via MHLink and the other via USB.

Report message to a moderator

Re: 2 computers 1 interface [message #87343 is a reply to message #87342]

Sat, 21 September 2019 17:07

dragosgd
Messages: 2
Registered: September 2019
Location: Dallas TX

Junior Member

Thank you BJ!

Report message to a moderator

Re: 2 computers 1 interface [message #87350 is a reply to message #87343]

Tue, 01 October 2019 06:05

kamal
Messages: 1
Registered: October 2019
Location: france

Junior Member

Edit : In fact, it is not the dual connection that is problematic, but only the output of the USB connection. I will contact the support.

Hi,
That's a good news, so I tried to connect 2 computers on the same 2882 card.
One is connected via ethernet.
The other one is connected via Usb.

The second computer receive the signal in good quality.
On the other way, from computer 2 to 1, I receive the sound distorted by
a sort of distorted clock, ( following the signal amplitude.)

Usb is four channel, same issue opening MIOConsole 3d on 1st or 2nd computer.

any suggestion ?
Thanks

[Updated on: Wed, 02 October 2019 05:54]

Report message to a moderator

Previous Topic:	Problem with Adat with 2 MH 2882 daisy chain
Next Topic:	Does anyone at Metric Halo monitor these forums?

Goto Forum:

-=] Back to Top [=-

[

]

Current Time: Thu Sep 21 22:03:27 EDT 2023