Metric Halo Discussion Forum
The place to talk MH!

Home   Search      Help    Register    Login
Home » Hardware » Interfaces » ULN8 3D power switch no longer functions
ULN8 3D power switch no longer functions [message #88037] Wed, 07 July 2021 12:12 Go to next message
recordsmith is currently offline  recordsmith
Messages: 4
Registered: March 2020
Location: Little Rock, AR
Junior Member
It is weird it just stays on as long as there is power. Is this normal. I don't recall this being the case in the past.

Jon
Re: ULN8 3D power switch no longer functions [message #88038 is a reply to message #88037] Wed, 07 July 2021 14:12 Go to previous message
bj is currently offline  bj
Messages: 527
Registered: July 2011
Senior Member
I can think of three possibilities:

1) Only the XLR power port is switched; if you plug the power into the 2.1mm coaxial power port then the front panel power switch is defeated.
2) There is a jumper on the power supply board. If you have installed the jumper, it bypasses the power switch
3) The switch has failed and needs to be replaced (its possible, but I am not aware of this having happened for any unit in the past).

Check possibilities 1+2. If it isn't one of them, then get in touch with support to get a replacement switch.
Previous Topic: 1st Gen 2882 Legacy with new iMac M1
Next Topic: Route New Strips to Host
Goto Forum:
  

[ PDF ]

Current Time: Sun Sep 26 14:04:32 EDT 2021