Metric Halo Discussion Forum: MIOConsole » Custom value for the channels number of the driver ?

Home

Help

Home » Hardware » MIOConsole » Custom value for the channels number of the driver ?

Show: Today's Messages :: Show Polls :: Message Navigator

Custom value for the channels number of the driver ? [message #88493]

Thu, 16 March 2023 04:06

MatthieuTibi
Messages: 60
Registered: July 2017
Location: Paris

Member

Hello,

To save some cpu I'd like to run the driver in 24 channels instead of 32 (16 is not enough in m'y configuration).
I remember having doing it a few versions of MIO ago... I managed to edit manualy a csnl3d file and it was working.

Now I'd like to do the same with the cnsl3d that I load by default at Mac OS start.
But it doesn't seems to work anymore, when I replace « 32 » on few lines by « 24 », nothing happens.

Is there's a way to do that ?
Thanks !

Report message to a moderator

Re: Custom value for the channels number of the driver ? [message #88494 is a reply to message #88493]

Thu, 16 March 2023 04:09

bj
Messages: 621
Registered: July 2011

Senior Member
Administrator

No, not really.

Even if you had manually edited the file and set it to 24, internally it would have been running at either 16 or 32 (not sure which).

The hardware only supports power of two channel counts, so 24 is not a valid setting. Its either 16 or 32. If you need more than 16, you'll have to roll with 32.

Sorry.

Best regards,

B.J.

Report message to a moderator

Re: Custom value for the channels number of the driver ? [message #88495 is a reply to message #88494]

Thu, 16 March 2023 04:23

MatthieuTibi
Messages: 60
Registered: July 2017
Location: Paris

Member

Ok thanks for your answer !

Report message to a moderator

Previous Topic:	Bass management/LFE processing question
Next Topic:	powermate volume jumps

Goto Forum:

-=] Back to Top [=-

[

]

Current Time: Sat Jun 03 08:34:10 EDT 2023