| problem with uln-2 [message #85459] |
Fri, 21 September 2012 11:35  |
kostas00
Messages: 2
Registered: September 2012
|
Junior Member |
|
|
i have a serious problem with my uln-2. the problem it began suddenly while i was listening music. i push the button to change the snapshot from 1 to 2 and then the card stuck. (that had happened again but this is not the problem) .then appear a message that i am using old version of drivers(i had 5.4) so i had to put the new version 5.5. i did it with the right process ,also i update and the new firmware but my mac still did not recognize the card from the system preferences.also when i open the console in the bar upside says
(uln2 offline)
my next movement was to do heart reset holding up the button and open the card.the problem still exists .
the strange was that in the front panel of the card when i open the card the luminous clues in the left side (power, s/r , int , firewire and locked ) blink!!!!!crazy things!! however if i hold up the button in that case stop to blink but without any positive result.
when i open the console if i make some change for example the s/r from 44 to 48 or something else such as the digital in from aes to spdif this did not informs the clues of the card in the frond panel.
i think it's serious.
kostas
[Updated on: Fri, 21 September 2012 11:48] Report message to a moderator |
|
|
|
|
|
|
|
| Re: problem with uln-2 [message #85477 is a reply to message #85462] |
Mon, 22 October 2012 01:53  |
dustpandave
Messages: 22
Registered: October 2012
|
Junior Member |
|
|
seems i am not the only one experiencing these problems... MH and Apple need to sort this out ASAP pleeaase!
Late 2011 MBP i7, 8 Gb RAM, OSX 10.8.2, Metric Halo ULN-2, Focal CMS65 Monitors
|
|
|
|
Home
Search
Help
Register
Login
]