Metric Halo Discussion Forum: Interfaces » Using a 2882 as an ADAT 'expander'

Home

Help

Home » Hardware » Interfaces » Using a 2882 as an ADAT 'expander'

Show: Today's Messages :: Show Polls :: Message Navigator

Using a 2882 as an ADAT 'expander' [message #87054]

Fri, 29 March 2019 06:34

StephenBennett
Messages: 14
Registered: July 2013

Junior Member

Hi all

I use the 2882 as an extra 8 channels with my ULN-2.

I'd like to take the 2882 to a colleague's studio and use it with their two channel interface which has optical in.

Does anyone do this? Use a 2882 just as an expander?

Will the 2882 just appear as extra in puts in the DAW? Or will we need to run the Console as well (no FW on the colleagues computer)

We'll just be using line inputs, so I assume we can save the 'state' of the 2882's inputs before the move?

Stephen

Report message to a moderator

Re: Using a 2882 as an ADAT 'expander' [message #87056 is a reply to message #87054]

Fri, 29 March 2019 14:02

bj
Messages: 621
Registered: July 2011

Senior Member
Administrator

Are you on 2d or on 3d? I'm guessing 2d since you mention FireWire.

With 2d you can set up the routing as desired and save a boot state.

If you need help with this, open a support ticket.

Report message to a moderator

Re: Using a 2882 as an ADAT 'expander' [message #87068 is a reply to message #87054]

Mon, 08 April 2019 07:48

StephenBennett
Messages: 14
Registered: July 2013

Junior Member

Thanks both--good to know.

Yes, 2d.

Stephen

Report message to a moderator

Previous Topic:	MH Link vs USB driver : Latency
Next Topic:	Lio 8 latency in logic 3d vs firewire

Goto Forum:

-=] Back to Top [=-

[

]

Current Time: Wed Jun 07 12:29:16 EDT 2023