Metric Halo Discussion Forum
The place to talk MH!

Home   Search      Help    Register    Login
Home » Hardware » Interfaces » MIO interfacing with Dante network (Dante connection methods)
MIO interfacing with Dante network [message #88153] Tue, 02 November 2021 17:05 Go to next message
Messages: 6
Registered: August 2019
Location: San Diego, Ca
Junior Member
I wish to connect my 3D-enabled LIO-8, ULN-8, and forthcoming ULN-8 mk4 devices into a Dante system at 96k.
What is the best known way to do connect with Dante (preferably staying in the digital domain) with minimal latency ?
Thanks !


MHLink 2.1.03
Mac 10.14
Logic Pro 10.5
Yamaha DM2000 console with Aviom 16/0-Y1 cards
Aviom D-800, and A-360 mixers
Re: MIO interfacing with Dante network [message #88197 is a reply to message #88153] Mon, 10 January 2022 16:01 Go to previous messageGo to next message
gantbd is currently offline  gantbd
Messages: 2
Registered: January 2022
Junior Member
Without direct AES67 or Dante support, your best bet will be to look at some of the Focusrite RedNet or RME options for accepting the digital outputs from your MIO boxes. Audinate also has the AVIO AES module, but it is only 2 channels. There may be others.

You would still need to use FW/USB/MHLink to control the units with MIOConsole.

I have done some minimal testing, and can confirm that Dante and MHLink can exist happily on the same network, though (IMO) an all in solution (e.g. MIOConsole over Dante via edge card) would be ideal.
Re: MIO interfacing with Dante network [message #88488 is a reply to message #88197] Mon, 27 February 2023 03:03 Go to previous messageGo to next message
wonshu is currently offline  wonshu
Messages: 3
Registered: May 2020
Junior Member
Any news on this?

I would also like to feed signal from an ULN-8 to the Behringer personal monitoring without an additional DA/AD conversion.
Re: MIO interfacing with Dante network [message #88721 is a reply to message #88153] Sat, 04 November 2023 00:32 Go to previous message
georgh is currently offline  georgh
Messages: 7
Registered: October 2022
Location: Austria
Junior Member
i want to bring this topic up on top:

BJ is there a chance that dante will be implemented in the near future? it would be a HUGE step forward for MH to have the possibility of integrating your Interfaces into dante environments.

any hint on this topic would be very appreciated. also if MH is not thinking about this at all, it would be good to know

Previous Topic: Analog Board for 3d Upgraded 2882 issues
Next Topic: 2882 and apple M2Pro chips
Goto Forum:

[ PDF ]

Current Time: Mon Dec 11 03:49:50 EST 2023