Metric Halo Discussion Forum
The place to talk MH!

Home   Search      Help    Register    Login
Today's Messages (off)  | Unanswered Messages (on)

Forum: Interfaces
 Topic: Ethernet câble questions
Ethernet câble questions [message #87706] Mon, 10 August 2020 07:16
autumn is currently offline  autumn
Messages: 3
Registered: July 2020
Junior Member
Hello !
Didn't found any clear informations on the internet : which kind of Ethernet cable must be used to connect for example my uln8 to my computer, over approximately 30 meters ?
Tried a few old cables found in my venue but did'nt worked (they worked with the mixing desk).
With a small cheap cable it's working.
I'm waiting for a cable I ordered, I choosed a cat 5e f/utp. But will It work ? Or do I need a f/ftp, or s/ftp ?
Anybody already tested some cables ?

Thank you !
 Topic: 2882 master board 2.02/2006 - 1.13/2001
2882 master board 2.02/2006 - 1.13/2001 [message #87705] Sun, 09 August 2020 18:12
jackjames2 is currently offline  jackjames2
Messages: 1
Registered: August 2020
Junior Member
Hello,

I recently upgraded to 3d with my ULN-2 through you. However, I have a 2882 that I am going to upgrade with a 2882 2d card expanded that I bought from another MH user who upgraded to 3d, as I can't afford a second 3d upgrade right now. I ordered a new ADAT I/O connector from you to replace the old one, as instructed by Jon Stern. As I was ready to install it today, I discovered that the 2882 expanded 2d card had a master board already attached to it. It was a 2.02 2006 version. My old one is a 1.13 2001. Is there any software upgrading from the Metric Halo site that I will have to do to make the unit updated and functional? I already have the M/O Console v.5 software installed on my Mac.

Thank you,

John

[Updated on: Sun, 09 August 2020 18:20]

Report message to a moderator




Current Time: Tue Aug 11 02:11:05 EDT 2020