Metric Halo Discussion Forum
The place to talk MH!

Home   Search      Help    Register    Login
Today's Messages (off)  | Unanswered Messages (on)

Forum: Interfaces
 Topic: ULN-8 WC - Master or Slave with Lynx Hilo (Windows)
ULN-8 WC - Master or Slave with Lynx Hilo (Windows) [message #87929] Wed, 24 February 2021 16:49
tompisa is currently offline  tompisa
Messages: 61
Registered: June 2012
Location: Germany
Member
I have a specific question and hope that also / maybe JB can comment on it.

I use a ULN8 as a pure (Mic Preamp) frontend converter for a Windows machine, connected to a Lynx Hilo.
I.e. I convert 8 Mic/ or instrument tracks with ULN 8 (3D) and send the Mio sum via AES/ EBU to the Lynx Hilo , which is connected to a Win10 machine with Nuendo. Is it better or does it have advantages / disadvantages that the ULN-8 sends the (master) clock to the Lynx Hilo (slave) via WordClock or AES/EBU or is it better if the Lynx Hilo sends its (master) clock to the ULN-8 (slave) via WC or AES/EBU ?

Or is it simply all the same from a qualitative point of view whether ULN-8 or Lynx is the MasterClock ?

thanks !

[Updated on: Wed, 24 February 2021 16:50]

Report message to a moderator

 Topic: MH 2882 no firewire light on front panel
MH 2882 no firewire light on front panel [message #87919] Sun, 21 February 2021 09:42
AndersC is currently offline  AndersC
Messages: 1
Registered: February 2021
Location: Denmark
Junior Member
Hi.

My Metric halo 2882 wont connect to macbook, and MIO console does not register any device.

I use the MIO 5.6.12.224

Theres no light in the FW on front panel.

When i connect FW cable only samplerate, clock, ditigal I/O, power and LOCKED is lit up.

I had the problem before where I ran a erase bootstate. but cant seem to find the file on my macbook.


Any help would be appreciated.

Thanks Smile
Forum: MIOConsole
 Topic: Monitor Controller Input Source selection via Hardware
Monitor Controller Input Source selection via Hardware [message #87917] Thu, 18 February 2021 21:43
TAMAN is currently offline  TAMAN
Messages: 1
Registered: February 2021
Location: Hamurg
Junior Member
Hi,

I'm not sure if this is an "How to" question or an suggestion but I was wondering if it is possible to select the Monitor Input Source via the the hardware encoders on the ULN8 3d.
Like switching to I/O Trim > Input, Control Mode: Monitor, push one of the eight encoders to select a Monitor Controller Input Source.
Or switching to I/O Trim > Output, Control Mode: Monitor, push one of the eight encoders to select a Monitor Controller Output Source.

I saw that it's possible with Key Commands. Which is already pretty cool.

Greetings



Current Time: Wed Feb 24 21:24:55 EST 2021