Metric Halo Discussion Forum: Interfaces » 2882 master board 2.02/2006

2882 master board 2.02/2006 - 1.13/2001 [message #87705]

Sun, 09 August 2020 18:12

jackjames2
Messages: 1
Registered: August 2020

Junior Member

Hello,

I recently upgraded to 3d with my ULN-2 through you. However, I have a 2882 that I am going to upgrade with a 2882 2d card expanded that I bought from another MH user who upgraded to 3d, as I can't afford a second 3d upgrade right now. I ordered a new ADAT I/O connector from you to replace the old one, as instructed by Jon Stern. As I was ready to install it today, I discovered that the 2882 expanded 2d card had a master board already attached to it. It was a 2.02 2006 version. My old one is a 1.13 2001. Is there any software upgrading from the Metric Halo site that I will have to do to make the unit updated and functional? I already have the M/O Console v.5 software installed on my Mac.

Thank you,

John

[Updated on: Sun, 09 August 2020 18:20]

Report message to a moderator