Metric Halo Discussion Forum
The place to talk MH!

Home   Search      Help    Register    Login
Home » Hardware » Interfaces » problem with uln-2 (problem with uln-2)
problem with uln-2 [message #85459] Fri, 21 September 2012 11:35 Go to previous message
kostas00 is currently offline  kostas00
Messages: 2
Registered: September 2012
Junior Member
i have a serious problem with my uln-2. the problem it began suddenly while i was listening music. i push the button to change the snapshot from 1 to 2 and then the card stuck. (that had happened again but this is not the problem) .then appear a message that i am using old version of drivers(i had 5.4) so i had to put the new version 5.5. i did it with the right process ,also i update and the new firmware but my mac still did not recognize the card from the system preferences.also when i open the console in the bar upside says
(uln2 offline)

my next movement was to do heart reset holding up the button and open the card.the problem still exists .

the strange was that in the front panel of the card when i open the card the luminous clues in the left side (power, s/r , int , firewire and locked ) blink!!!!!crazy things!! however if i hold up the button in that case stop to blink but without any positive result.

when i open the console if i make some change for example the s/r from 44 to 48 or something else such as the digital in from aes to spdif this did not informs the clues of the card in the frond panel.

i think it's serious.

[Updated on: Fri, 21 September 2012 11:48]

Report message to a moderator

Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: New 2882 user observations/problems pls help
Next Topic: ULN-2 crackling/clicking
Goto Forum:

[ PDF ]

Current Time: Fri Jun 09 06:40:58 EDT 2023