Metric Halo Discussion Forum: Interfaces » ULN 2 with multiple monitors

ULN 2 with multiple monitors [message #85720]

Mon, 01 April 2013 15:17

pikolo
Messages: 7
Registered: April 2013

Junior Member

Hello everyone. New comer on this forum.

I'm seriously considering the ULN 2 and I'd like to ask some question about monitoring.

At first, I wanted to use a dangerous source as DAC + monitor control as I thought the ULN 2 could only feed one pair of speaker.

But then reading the manual, I've seen some routing suggestion showing main speakers connected to the monitor outs and secondary to the analog outs. But I'm not sure if those outs are "replicated" or if they act as totally independent outputs.

Could I do this? :

- Have my main monitors connected to the monitor outs and thus affected by the monitor pot.

- Have my single avantone mix cube connected to Analog 1 out, which would get the same signal as the main but summed to mono through the MIO. Meaning also that it would not have a level pot but I could adjust the output level in the software, right?

- Toggle between those 2 sets by recalling snapshots with the arrow buttons on the interface (Snapshot 1 would have the main on and the secondary muted and the contrary for snapshot 2)

Anyone could enlighten me on this topic? Would be gladly appreciated as if my thoughts are right, I could then use the ULN 2 as the central piece of my studio and don't care about pre, conversion, monitoring for a while Wink

Thanks a lot

Report message to a moderator