Metric Halo Discussion Forum: Interfaces

Fri, 21 August 2015 14:56

Guitarwhisperer
Messages: 19
Registered: August 2013
Location: Santa Fe, NM

Junior Member

I'm very new to audio recording...... I have a ULN-2 and would love to take advantage of the Halo-Verb and a few other offerings. However, I have been unable to get Halo verb to stick to a recording inside my DAW (Reaper) that I can export or render. I'm sure it is a routing issue I don't seem to comprehend, even though I've watched the tutorials and asked a few guys.

I've put the direct outs at the bottom on the channel, I can hear the Halo-Verb but when I render there is no reverb on the finished product. I use the "basic set-up" in the templates. I hoping someone can help provide a solution to my problem...... I'm dying to use the stuff in the production bundle.

Another question: I'm on the verge of getting either a ULN-8 or a LIO-+4. Is there any difference in the sound quality between the two? If there is not I'm opting for the LIO- +4.

Thanks,

Michael

Report message to a moderator