Metric Halo Discussion Forum: Interfaces » my 2882 analog output 3-8 was distorted

my 2882 analog output 3-8 was distorted [message #88319]

Sat, 30 July 2022 17:17

tawansqweezme
Messages: 1
Registered: July 2022

Junior Member

hello i need some help

i use 2882 to run a music livestream gig and want to route a vocal track to live monitor speaker for musician
so in mioconsole3d, on vocal track i assign a bus for output it via cue controller
the monitor speaker was Roland kc150 and connected by trs jack to xlr

At first, i connect an amp on analog out3
and they start to produce a continuous nasty digital distortion when move gain above -80
when i speak on microphone i can hear my voice but badly distort
so i try the another analog out from 3 to 8 and still have same distort

i try to switch between line +4/-10 in analog i/o pane with no luck

but at analog out 1/2 everything was fine

i also try use a Monitor controller to output via analog out3-8 it was same
but with analog out1/2 it was fine

try so many cable unbalance and balance

i feel it's very strange like output1/2 was the only out i can work with
Are output 1/2 have the gain out same as the other output?

[Updated on: Sat, 30 July 2022 17:22]

Report message to a moderator